Fused Deposition Modeling and microwave sintering of 3Y-TZP samples

Моделирование наплавлением и микроволновое спекание образцов 3Y-TZP
Christophe Meunier, Clémence Petit, Lucas Manceaux, Hugo Rivera, Hubert Taxil
2023-05-26

3 mol% yttria-stabilized zirconia (3Y-TZP)Fused Deposition Modeling (FDM)debinding (chemical and thermal)microwave sintering (MW)multimode microwave instrumented cavity
Fully dense zirconia parts were produced by shaping using Fused Deposition Modeling (FDM) and microwave (MW) sintering. The samples were obtained using an usual 3D printer and a commercial 3 mol% yttria-stabilized zirconia filament. The printing parameters were adapted to the printer and the filament. Then, the samples were debinded with a two-step process, i.e., chemical and thermal debinding. The debinded samples were sintered in a multimode microwave instrumented cavity. Full density was achieved with shorter thermal cycles compared with conventional sintering. Dilatometric curves for microwave sintering show similar behavior during densification, as in conventional sintering. The evolution of measured temperature vs time confirms the good control of the thermal cycle allowed by the MW device.
1
A commercial 3Y-TZP filament and a standard 3D printer were successfully used after adapting printing parameters to produce printable green parts.
2
Debinding was performed via a two-step chemical and thermal process prior to microwave sintering.
3
Dilatometric curves show similar densification behavior for microwave sintering and conventional sintering.
4
Fully dense 3 mol% yttria-stabilized zirconia (3Y-TZP) parts were produced by combining Fused Deposition Modeling (FDM) and microwave (MW) sintering.
5
Measured temperature versus time evolution confirms good control of the thermal cycle by the microwave sintering device.
6
Microwave sintering in a multimode instrumented cavity achieved full density with shorter thermal cycles compared with conventional sintering.

3 mol% yttria-stabilized tetragonal zirconia polycrystal (3Y-TZP) samples produced by Fused Deposition Modeling and microwave sintering

Densification, microstructural evolution and thermal-cycle control during debinding and microwave sintering of FDM-printed 3Y-TZP, including achievement of full density, comparison with conventional sintering, and dilatometric/temperature-time behavior

Publication Details
Publication Date
2023-05-26
Journal
Publisher
ISSN
Cited by
5
Access Type
Author Information
Authors
Christophe Meunier
Clémence Petit
Lucas Manceaux
Hugo Rivera
Hubert Taxil
Explore further
Open the scid.ai AI chat with a ready-made request: it will find papers on a similar topic and help build a literature review.
Find similar papers in the chat →
Make a presentation
100%