“Leaky Dielectric” Model for the Suppression of Dynamic $R_{\mathrm{ON}}$ in Carbon-Doped AlGaN/GaN HEMTs
Модель «протекающего диэлектрика» для подавления динамического разброса RON в AlGaN/GaN HEMT с легированием углеродом
2017-06-06
SCID: 54.1/yzk3z7py
Discuss with AI
GaN buffer leakagecarbon-doped AlGaN/GaN HEMTsdynamic RON dispersionleaky dielectric modelsubstrate bias ramps
Figures from the paper
Abstract (AI)
GaN-on-Si power switching transistors that use carbon-doped epitaxy are highly vulnerable to dynamic RONdispersion, leading to reduced switching efficiency. In this paper, we identify the causes of this dispersion using substrate bias ramps to isolate the leakage paths and trapping locations in the epitaxy and simulation to identify their impact on the device characteristics. It is shown that leakage can occur both vertically and laterally, and we suggest that this is associated not only with bulk transport, but also with extended defects as well as hole gases at heterojunctions. For exactly the same epitaxial design, it is shown using a “leaky dielectric” model that depending on the leakage paths, dynamic RONdispersion can vary between insignificant and infinite. An optimum leakage configuration is identified to minimize dispersion requiring a resistivity which increases with depth in the buffer stack. It is demonstrated that leakage through the undoped GaN channel is required over the entire gate to drain gap, and not just under the contacts, in order to fully suppress dispersion.
Key Findings
1
Carbon-doped GaN-on-Si power switching transistors exhibit dynamic RON dispersion that can substantially reduce switching efficiency.
2
For identical epitaxial designs, the leaky-dielectric model predicts dynamic RON dispersion ranging from insignificant to infinite depending on leakage-path configuration.
3
Leakage through the undoped GaN channel must extend across the entire gate-to-drain gap, rather than only beneath contacts, to fully suppress dynamic RON dispersion.
4
Minimum dispersion requires an optimized buffer resistivity that increases with depth through the epitaxial stack.
5
Substrate-bias ramps and simulations identify both vertical and lateral leakage paths, involving bulk transport, extended defects, and hole gases at heterojunctions.
Research Object
carbon-doped epitaxial GaN-on-Si power switching transistors (AlGaN/GaN HEMTs)
Research Subject
the leakage-path and trapping mechanisms governing dynamic RON dispersion, and their optimization through the buffer resistivity profile to suppress dispersion
Publication Details
Publication Date
2017-06-06
Journal
Publisher
ISSN
Cited by
245
Open access PDF
Access Type
Author Information
Download PDF
Subscribe to digest
References available in scid.ai1
Cited by8
The 2018 GaN power electronics roadmap2018
GaN-based power devices: Physics, reliability, and perspectives2021
Trapping phenomena and degradation mechanisms in GaN-based power HEMTs2017
Microwave and Millimeter-Wave GaN HEMTs: Impact of Epitaxial Structure on Short-Channel Effects, Electron Trapping, and Reliability2023
Impact of carbon in the buffer on power switching GaN-on-Si and RF GaN-on-SiC HEMTs2021
“Kink” in AlGaN/GaN-HEMTs: Floating Buffer Model2018
Substrate Bias Stress Induced Kink Effect in GaN-on-Silicon High-Electron-Mobility Transistor2023
Experimental and Theoretical Investigation of Kink Behavior in C-Doped GaN-on-Si Power HEMTs Under Substrate Bias and Temperature Variations2026