Methane Slip, Black Carbon and Greenhouse Gas Emissions from an LNG-Fuelled Cruise Ship: Insights from FuelEU and IMO Engine Load Monitoring Methodologies

Выбросы проскока метана, чёрного углерода и парниковых газов с круизного судна, работающего на СПГ: результаты применения методик FuelEU и ИМО для мониторинга нагрузки двигателя
Sagot Benoit, Raphael Defossez, Aurelia Miquel
2026-07-17

Engine Load MonitoringFuelEU MaritimeLNG-fuelled cruise shipblack carbon emissionsmethane slip
Liquefied natural gas (LNG) is increasingly used in maritime propulsion systems to reduce atmospheric emissions. However, methane slip from dual-fuel engines remains a critical limitation due to the high global warming potential of methane. This study presents a comprehensive experimental assessment of greenhouse gas (GHG) emissions from a new-generation low-pressure four-stroke dual-fuel (LPDF 4-S) engine installed on a cruise vessel and operating on both LNG and marine gas oil (MGO). Measurements were carried out during full-scale sea trials under real navigation conditions. Results show that methane slip remains strongly dependent on engine load, with low and stable values at medium-to-high loads (1.95 g·kWh−1 average over the 60–90% range) and a value of 5.6 g·kWh−1 at 26% engine load. Compared with the previous engine generation (46DF), the 46TS-DF engine exhibits an approximate 18% reduction in methane slip above 60% load. On a well-to-wake basis, this results in an overall carbon dioxide CO2-equivalent emission reduction of about 6%, of which 42% is attributable to methane slip reduction and the remainder to improved energy efficiency. In contrast, switching from MGO to LNG operation leads to a 21% decrease in CO2-equivalent emissions. Black carbon (BC) emissions were measured and as expected despite the limited number of available studies, they were found to be significantly lower in LNG mode, with reductions exceeding 90% compared with MGO operation. Finally, an Engine Load Monitoring (ELM) analysis based on one year of operational data highlights the strong influence of vessel operating profiles on methane slip. The application of both International Maritime Organization (IMO) and FuelEU Maritime methodologies yields consistent methane slip coefficients (1.34% and 1.36%, respectively), significantly lower than current default values, noting that these estimates do not include crankcase emissions. These results demonstrate the importance of integrating real operational conditions into emission assessment frameworks for LNG-fuelled vessels.
1
Methane slip from the LPDF 4-S engine depends strongly on load, averaging 1.95 g·kWh−1 at 60–90% load but reaching 5.6 g·kWh−1 at 26% load.
2
One year of operational data produced consistent methane-slip coefficients under IMO and FuelEU methodologies—1.34% and 1.36%, respectively—both substantially below current default values, excluding crankcase emissions.
3
Switching from MGO to LNG reduces CO2-equivalent emissions by 21% and black carbon emissions by more than 90%.
4
The newer 46TS-DF engine reduces methane slip by approximately 18% above 60% load compared with the previous 46DF generation.
5
Well-to-wake CO2-equivalent emissions decrease by about 6% through engine improvements, with 42% of this reduction attributable to lower methane slip and the remainder to improved efficiency.

A new-generation low-pressure four-stroke dual-fuel (LPDF 4-S) engine installed on an LNG-fuelled cruise ship and operated on LNG and marine gas oil (MGO)

Load- and fuel-dependent methane slip, black carbon and greenhouse-gas emissions, including well-to-wake CO2-equivalent performance and methane-slip coefficients estimated using IMO and FuelEU Maritime engine-load monitoring methodologies

Publication Details
Publication Date
2026-07-17
Journal
Publisher
ISSN
Access Type
Author Information
Authors
Sagot Benoit
Raphael Defossez
Aurelia Miquel
Explore further
Open the scid.ai AI chat with a ready-made request: it will find papers on a similar topic and help build a literature review.
Find similar papers in the chat →
Make a presentation
100%