Morphology and Stability of CO 2 -in-Water Foams with Nonionic Hydrocarbon Surfactants
Морфология и стабильность пен «диоксид углерода в воде» с неионогенными углеводородными поверхностно-активными веществами
2010-03-26
SCID: 54.1/h5hcs2za
Discuss with AI
CO2 sequestrationCO2-in-water foamsCapillary rheologyNonionic hydrocarbon surfactantsOstwald ripening
Figures from the paper
Abstract (AI)
The morphologies, stabilities, and viscosities of high-pressure carbon dioxide-in-water (C/W) foams (emulsions) formed with branched nonionic hydrocarbon surfactants were investigated by in situ optical microscopy and capillary rheology. Over two dozen hydrocarbon surfactants were shown to stabilize C/W foams with Sauter mean bubble diameters as low as 1 to 2 microm. Coalescence of the C/W foam bubbles was rare for bubbles larger than about 0.5 microm over a 60 h time frame, and Ostwald ripening became very slow. By better blocking of the CO(2) and water phases with branched and double-tailed surfactants, the interfacial tension decreases, the surface pressure increases, and the C/W foams become very stable. For branched surfactants with propylene oxide middle groups, the stabilities were markedly lower for air/water foams and decane-water emulsions. The greater stability of the C/W foams to coalescence may be attributed to a smaller capillary pressure, lower drainage rates, and a sufficient surface pressure and thus limiting surface elasticity, plus small film sizes, to hinder spatial and surface density fluctuations that lead to coalescence. Unexpectedly, the foams were stable even when the surfactant favored the CO(2) phase over the water phase, in violation of Bancroft's rule. This unusual behavior is influenced by the low drainage rate, which makes Marangoni stabilization of less consequence and the strong tendency of emerging holes in the lamella to close as a result of surfactant tail flocculation in CO(2). The high distribution coefficient toward CO(2) versus water is of significant practical interest for mobility control in CO(2) sequestration and enhanced oil recovery by foam formation.
Key Findings
1
Branched and double-tailed surfactants reduced interfacial tension and increased surface pressure, producing exceptionally stable CO₂-in-water foams.
2
Bubble coalescence was rare for bubbles larger than approximately 0.5 μm over 60 hours, while Ostwald ripening became very slow.
3
CO₂-in-water foams with branched surfactants were markedly more stable than corresponding air/water foams and decane–water emulsions.
4
Foam stability persisted even when surfactants preferentially partitioned into CO₂, contrary to Bancroft’s rule, due to low drainage and closure of emerging lamellar holes through tail flocculation in CO₂.
5
High surfactant partitioning toward CO₂ is practically relevant for foam-based mobility control in CO₂ sequestration and enhanced oil recovery.
6
More than two dozen branched nonionic hydrocarbon surfactants stabilized high-pressure CO₂-in-water foams with Sauter mean bubble diameters of 1–2 μm.
Research Object
High-pressure carbon dioxide-in-water foams formed with branched nonionic hydrocarbon surfactants
Research Subject
Foam morphology, stability, viscosity, interfacial behavior, and mechanisms governing bubble coalescence and Ostwald ripening
Publication Details
Publication Date
2010-03-26
Journal
Publisher
ISSN
Cited by
156
Access Type
Author Information
Download PDF
Subscribe to digest
Cited by4
Recent Advances in Surfactant EOR2011
Switchable Nonionic to Cationic Ethoxylated Amine Surfactants for CO2 Enhanced Oil Recovery in High-Temperature, High-Salinity Carbonate Reservoirs2013
Hybrid surfactant-nanoparticles assisted CO2 foam flooding for improved foam stability: A review of principles and applications2021
Ultradry Carbon Dioxide-in-Water Foams with Viscoelastic Aqueous Phases2015