Effect of in situ thermal treatment on interlayer adhesion of 3D printed polyetherimide (PEI) parts produced by fused deposition modeling (FDM)

Влияние термической обработки in situ на межслойную адгезию деталей из полиэфиримида (PEI), изготовленных методом послойного наплавления (FDM)
Khanh Q. Nguyen, Pascal Yves Vuillaume, Lei Hu, Andro Vachon, Audrey Diouf-Lewis, Pier-Luc Marcoux, Mathieu Robert, Saïd Elkoun
2024-03-11

Additive manufacturingFused deposition modeling (FDM)In situ thermal treatmentInterlayer adhesionPolyetherimide (PEI)
Polyetherimide (PEI) possesses remarkable mechanical and thermal properties that make it a promising high-performance material for a wide range of applications. In addition to its simple processability, adhesive properties, and minimal smoke emission when heated, PEI is a suitable material for additive manufacturing. Because of its low cost and straightforward method, fused deposition modeling, or FDM, is a popular additive manufacturing technique for extruding thermoplastic filaments. Parts printed with the FDM approach, on the other hand, have common drawbacks such as low mechanical strength, shape inaccuracy, high porosity, void formation, interlayer adhesion problems, and anisotropic properties. The purpose of this study was to evaluate the effect of the thermal process during printing on the interlayer adhesion strength and the mechanical performances of PEI. The thermal treatment was done on a radiant heating system at 390 oC with a printing speed of 35 mm/s. In this study, parts printed with and without radiant heating system were characterized and analyzed with scanning electron microscopy (SEM), optical microscopy (OM), X-ray microtomography (µ-CT), optical profilometry (OP), atomic force microscopy (AFM), dynamic mechanical analysis (DMA), and tensile tests. The results revealed that the treated specimen exhibited better interlayer adhesion between printed layers. The interfacial voids were less visible in treated specimens. Furthermore, the treated specimen had lower porosity (5%) than the untreated one (8%). Moreover, increases of 183% in tensile strength, 22% in elastic modulus, and 190% in elongation at break were observed for treated specimens when compared to untreated ones.
1
Compared with untreated specimens, treated parts showed 183% higher tensile strength, 22% higher elastic modulus, and 190% greater elongation at break.
2
In situ radiant heating during FDM printing at 390 °C and 35 mm/s improved interlayer adhesion in PEI parts.
3
Radiant-treated PEI specimens exhibited fewer visible interfacial voids and reduced porosity, from 8% to 5%.
4
The study evaluated thermal-treatment effects using microscopy, microtomography, profilometry, atomic force microscopy, dynamic mechanical analysis, and tensile testing.

3D-printed polyetherimide (PEI) parts produced by fused deposition modeling (FDM), with and without in situ radiant thermal treatment

The effect of in situ thermal treatment during printing on interlayer adhesion, porosity, and mechanical performance of the PEI parts

Publication Details
Publication Date
2024-03-11
Journal
Publisher
ISSN
Access Type
Author Information
Authors
Khanh Q. Nguyen
Pascal Yves Vuillaume
Lei Hu
Andro Vachon
Audrey Diouf-Lewis
Pier-Luc Marcoux
Mathieu Robert
Saïd Elkoun
Explore further
Open the scid.ai AI chat with a ready-made request: it will find papers on a similar topic and help build a literature review.
Find similar papers in the chat →
Make a presentation
100%