Influence of Print Orientation on Surface Roughness in Fused Deposition Modeling (FDM) Processes
Влияние ориентации печати на шероховатость поверхности в процессах послойного наплавления (FDM)
2019-11-21
SCID: 54.1/cttz9yes
Discuss with AI
Arithmetical mean height (Ra)Fused deposition modelingPLA samplesPrint orientation angleSurface roughness
Figures from the paper
Abstract (AI)
In the present paper, we address the influence of print orientation angle on surface roughness obtained in lateral walls in fused deposition modelling (FDM) processes. A geometrical model is defined that considers the shape of the filaments after deposition, in order to define a theoretical roughness profile, for a certain print orientation angle. Different angles were considered between 5° and 85°. Simulated arithmetical mean height of the roughness profile, Ra values, were calculated from the simulated profiles. The Ra simulated results were compared to the experimental results, which were carried out with cylindrical PLA (polylactic acid) samples. The simulated Ra values were similar to the experimental values, except for high angles above 80°, where experimental roughness decreased while simulated roughness was still high. Low print orientation angles show regular profiles with rounded peaks and sharp values. At a print orientation angle of 85°, the shape of the profile changes with respect to lower angles, showing a gap between adjacent peaks. At 90°, both simulated and experimental roughness values would be close to zero, because the measurement direction is parallel to the layer orientation. Other roughness parameters were also measured: maximum height of profile, Rz, kurtosis, Rku, skewness, Rsk, and mean width of the profile elements, Rsm. At high print orientation angles, Rz decreases, Rku shifts to positive, Rsk slightly increases, and Rsk decreases, showing the change in the shape of the roughness profiles.
Key Findings
1
A geometrical filament-deposition model predicts lateral-wall roughness profiles and simulated Ra values across print orientation angles from 5° to 85°.
2
At 90°, simulated and experimental roughness are expected to approach zero because the measurement direction is parallel to the layer orientation.
3
Increasing orientation angle changes other roughness characteristics: Rz decreases, kurtosis shifts positive, and skewness and profile-element width vary with profile shape.
4
Low print orientation angles produce regular roughness profiles with rounded peaks and sharp valleys, whereas 85° produces gaps between adjacent peaks.
5
Simulated Ra values closely match experimental measurements from cylindrical PLA samples, except above 80°, where experimental roughness decreases while simulations remain high.
Research Object
lateral walls of cylindrical PLA samples fabricated by fused deposition modeling (FDM)
Research Subject
the effect of print orientation angle on surface roughness profiles and roughness parameters
Publication Details
Publication Date
2019-11-21
Journal
Publisher
ISSN
Cited by
131
Open access PDF
Access Type
Author Information
Download PDF
Subscribe to digest
References available in scid.ai1
Cited by4
Influence of Infill Patterns Generated by CAD and FDM 3D Printer on Surface Roughness and Tensile Strength Properties2021
Development of AM Technologies for Metals in the Sector of Medical Implants2020
Raster Orientation Effects on the Adhesion of iCVD-Deposited PSA Thin Films on FDM-Printed PLA2026
Effect of in situ thermal treatment on interlayer adhesion of 3D printed polyetherimide (PEI) parts produced by fused deposition modeling (FDM)2024