Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity (Recommendations 1984)
Представление данных по физической адсорбции в газ/твердая фаза с особым вниманием к определению площадей поверхности и пористости (Рекомендации 1984)
1985-01-01
SCID: 54.1/q45ztdc6
Discuss with AI
adsorption isothermsgas/solid systemsphysisorptionporosity determinationsurface area determination
Figures from the paper
Abstract (AI)
micropore filling.The BET method is unlikely to yield a value of the actual surface area if the isotherm is either Type I or Type III; but both Type II and Type IV isotherms are, in general, amenable to the BET analysis, provided that the value of C is neither too low nor too high and that the BET plot is linear in the region of the isotherm containing Point B.The computation of mesopore size distribution is valid only if the isotherm is of Type IV, but in view of the complexity of most pore systems little is to be gained by the application of an elaborate method of computation.If a Type I isotherm exhibits a nearly constant adsorption at high relative pressure, the micropore volume is given by the amount adsorbed at the plateau.At present there is no reliable procedure available for the computation of the micropore size distribution from a single isotherm.A check list is recommended to assist authors in the measurement of adsorption isotherms and the presentation of the data in the primary literature. CONTENTS SECTION 1.Recent work has drawn attention to the complexity of capillary condensation in pore networks and has indicated that a pore size distribution curve derived from the desorption branch of the loop is likely to be unreliable if pore blocking effects occur.It is significant that a very steep desorption branch is usually found if the lower closure point of the loop is located at the limiting p/p° (see Section 5.3).In particular, the
Key Findings
1
Emphasizes the importance of detailed reporting of experimental conditions and analysis methods when determining surface area and porosity.
2
Provides standardized recommendations for reporting physisorption data for gas/solid systems, focusing on surface area and porosity determination.
3
Specifies procedures and conventions to ensure consistency and comparability of surface area and porosity measurements across studies.
Research Object
Gas/solid physisorption systems used to determine surface area and porosity
Research Subject
Standards/recommendations for reporting physisorption data and methods to determine surface area and porosity from gas adsorption measurements
Publication Details
Publication Date
1985-01-01
Journal
Publisher
ISSN
Cited by
24802
Open access PDF
Access Type
Author Information
Download PDF
Subscribe to digest
Cited by9
Review on the science and technology of water desalination by capacitive deionization2013
Characterization and Analysis of Porosity and Pore Structures2015
High-silica zeolites for adsorption of organic micro-pollutants in water treatment: A review2018
Carbon materials for ion-intercalation involved rechargeable battery technologies2020
Water adsorption in UiO-66: the importance of defects2014
In Situ FTIR Spectroscopy for Scanning Accessible Active Sites in Defect-Engineered UiO-662023
Yolk‐Shell Porous Microspheres of Calcium Phosphate Prepared by Using Calcium L ‐Lactate and Adenosine 5′‐Triphosphate Disodium Salt: Application in Protein/Drug Delivery2015
Direct One-pot Synthesis of Highly Tunable Mixed-linker UiO-66-(SH)2 Metal-Organic Frameworks: Enroute Toward Robust Sulfonic Acid Tagged UiO-66 Architectures2022
Influence of Adsorption of Electrically Neutral Reactants on the Formation of Electrical Double Layers in Solid Acid Catalysts and Its Relation to Catalytic Activity2025