Design, Build, and Initial Testing of a Portable Methane Measurement Platform
Проектирование, сборка и первичные испытания портативной платформы для измерения метана
2025-03-21
SCID: 54.1/9bmedhk7
Discuss with AI
NDIR sensorTDLASWATCH4ERSmethane emission quantificationmethane measurement
Figures from the paper
Abstract (AI)
The quantification of methane concentrations in air is essential for the quantification of methane emissions, which in turn is necessary to determine absolute emissions and the efficacy of emission mitigation strategies. These are essential if countries are to meet climate goals. Large-scale deployment of methane analyzers across millions of emission sites is prohibitively expensive, and lower-cost instrumentation has been recently developed as an alternative. Currently, it is unclear how cheaper instrumentation will affect measurement resolution or accuracy. To test this, the Wireless Autonomous Transportable Methane Emission Reporting System (WATCH4ERS) has been developed, comprising four commercially available sensing technologies: metal oxide (MOx,), Non-dispersion Infrared (NDIR), integrated infrared (INIR), and tunable diode laser absorption spectrometer (TDLAS). WATCHERS is the accumulated knowledge of several long-term methane measurement projects at Colorado State University’s Methane Emission Technology Evaluation Center (METEC), and this study describes the integration of these sensors into a single unit and reports initial instrument response to calibration procedures and controlled release experiments. Specifically, this paper aims to describe the development of the WATCH4ERS unit, report initial sensor responses, and describe future research goals. Meanwhile, future work will use data gathered by multiple WATCH4ERS units to 1. better understand the cost–benefit balance of methane sensors, and 2. identify how decreasing instrumentation costs could increase deployment coverage and therefore inform large-scale methane monitoring strategies. Both calibration and response experiments indicate the INIR has little practical use for measuring methane concentrations less than 500 ppm. The MOx sensor is shown to have a logarithmic response to methane concentration change between background and 600 ppm but it is strongly suggested that passively sampling MOx sensors cannot respond fast enough to report concentrations that change in a sub-minute time frame. The NDIR sensor reported a linear change to methane concentration between background and 600 ppm, although there was a noticeable lag in reporting changing concentration, especially at higher values, and individual peaks could be observed throughout the experiment even when the plumes were released 5 s apart. The TDLAS sensor reported all changes in concentration but remains prohibitively expensive. Our findings suggest that each sensor technology could be optimized by either operational design or deployment location to quantify methane emissions. The WATCH4ERS units will be deployed in real-world environments to investigate the utility of each in the future.
Key Findings
1
INIR showed little practical utility for measuring methane concentrations below 500 ppm.
2
MOx exhibited a logarithmic response from background to 600 ppm, but passive sampling was likely too slow for sub-minute concentration changes.
3
NDIR responded linearly from background to 600 ppm but showed reporting lag at higher concentrations and resolved individual plumes released five seconds apart.
4
TDLAS captured all concentration changes but remained prohibitively expensive; sensor technologies may require optimization through operational design or deployment location.
5
The WATCH4ERS platform integrates four methane-sensing technologies—MOx, NDIR, INIR, and TDLAS—into a single portable unit for calibration and downwind testing.
Research Object
WATCH4ERS portable methane measurement platform and its integrated MOx, NDIR, INIR, and TDLAS methane sensors
Research Subject
Sensor response characteristics, including calibration, accuracy, sensitivity, temporal resolution, lag, and suitability for measuring changing methane concentrations and quantifying emissions
Publication Details
Publication Date
2025-03-21
Journal
Publisher
ISSN
Cited by
5
Open access PDF
Access Type
Author Information
Download PDF
Subscribe to digest
References available in scid.ai4
Methane Mitigation: Methods to Reduce Emissions, on the Path to the Paris Agreement2020
Advanced Leak Detection and Quantification of Methane Emissions Using sUAS2021
Assessing the Progress of the Performance of Continuous Monitoring Solutions under a Single-Blind Controlled Testing Protocol2024
Point Sensor Networks Struggle to Detect and Quantify Short Controlled Releases at Oil and Gas Sites2024