Transport and ionization of sputtered atoms in high-power impulse magnetron sputtering discharges

Транспорт и ионизация распылённых атомов в разрядах импульсного магнетронного распыления высокой мощности
J. Vlček, Šimon Kos, Tomáš Kozák
2013-02-13

Copper targetHigh-power impulse magnetron sputteringIonized fractionNon-stationary two-zone modelSputtered atom transport
We use a non-stationary two-zone model to verify predictions of a steady-state phenomenological model (Vl?ek and Burcalov?) under the conditions in typical high-power impulse magnetron sputtering discharges (copper target of 50?mm diameter, argon pressure of 1?Pa, rectangular voltage pulses of 200??s length with amplitudes from 400 to 1000?V and repetition frequency of 100?Hz). It is shown that the steady-state phenomenological model provides a reliable description of fundamental deposition parameters characterizing efficiency of magnetron sputtering and the transfer of target material ions to the substrate in these discharges with relatively long steady-state discharge regimes established during pulses. Based on the results, we recommend to lower the magnetic field strength in a magnetron system at a fixed average target power density in a pulse and thereby use a higher magnetron voltage in order to enhance the deposition rate and keep or even increase the ionized fraction of sputtered target material atoms in the flux onto the substrate.
1
A non-stationary two-zone model confirms that the steady-state phenomenological model reliably describes sputtering efficiency and ion transfer under typical HiPIMS conditions.
2
At fixed average target power density during a pulse, reducing magnetic field strength enables higher magnetron voltage operation.
3
Lower magnetic field strength combined with higher voltage can enhance deposition rate while maintaining or increasing the ionized fraction of sputtered target atoms reaching the substrate.
4
The steady-state model remains applicable because relatively long voltage pulses establish quasi-steady discharge regimes in the investigated copper magnetron discharges.

Sputtered copper atoms and their ions transported from a copper target to the substrate in high-power impulse magnetron sputtering discharges

Their transport and ionization, including deposition efficiency, ionized fraction in the substrate flux, and deposition rate under varying discharge voltage and magnetic-field conditions

Publication Details
Publication Date
2013-02-13
Journal
Publisher
ISSN
Cited by
23
Access Type
Author Information
Authors
J. Vlček
Šimon Kos
Tomáš Kozák
Explore further
Open the scid.ai AI chat with a ready-made request: it will find papers on a similar topic and help build a literature review.
Find similar papers in the chat →
Make a presentation
100%