The evolution of the plasma potential in a HiPIMS discharge and its relationship to deposition rate
Эволюция плазменного потенциала в разряде HiPIMS и его связь со скоростью осаждения
2010-06-15
SCID: 54.1/aeafgfe3
Discuss with AI
HiPIMS dischargedeposition rateelectron-emitting probeplasma potentialpotential barrier
Figures from the paper
Abstract (AI)
An electron-emitting probe has been used to measure the temporal evolution of the plasma potential V p along a line from target (Ti) to substrate above the racetrack in a high-power impulse magnetron sputtering discharge pulsed at 100 Hz. The 20 ns time-resolution of the probe allowed us to observe the highly dynamic nature of V p as the discharge voltage waveform develops, with large negative V p values (−210 V) and strong potential gradients existing in the magnetic trap region in the first 6 to 8 µs. After 55 to 60 µs, V p is elevated towards ground potential (0 V) and the bulk electric field collapses. Outside the magnetic trap, i.e. on the open field lines, V p reveals much smaller axial and temporal variations, similar to those observed in conventional pulsed dc magnetrons. At standard conditions (Ar pressure of 0.54 Pa and 650 W average power), the results show that for over 50% of the 100 µs plasma 'on-time' the spatial structure of V p provides a large potential barrier for the sputtered post-ionized species so impeding their transport and deposition at the substrate. This barrier is reduced markedly (by 50%) through a small reduction in the magnetic field strength (33% at the target) so increasing the deposition rate by a factor of 6 at a typical position of the substrate ( z = 100 mm). The structure of V p is marginally sensitive to changes in pressure (over the range 0.54 to 1.08 Pa), but more strongly dependent on the applied power (over the range 650 to 950 W).
Key Findings
1
After 55–60 µs, the plasma potential approaches ground and the bulk electric field collapses; open-field regions show much smaller variations.
2
For more than 50% of the 100 µs plasma-on time, the potential structure forms a barrier that impedes post-ionized sputtered-species transport to the substrate.
3
Reducing the magnetic field strength by 33% lowers the transport barrier by 50% and increases the deposition rate sixfold at 100 mm substrate distance.
4
The plasma-potential structure is only marginally pressure-dependent between 0.54 and 1.08 Pa but depends more strongly on applied power between 650 and 950 W.
5
Time-resolved probe measurements reveal highly dynamic plasma potentials, reaching −210 V with strong magnetic-trap gradients during the first 6–8 µs.
Research Object
plasma potential in a high-power impulse magnetron sputtering (HiPIMS) discharge and the transport of sputtered post-ionized species to the substrate
Research Subject
the temporal and spatial evolution of the plasma potential, its potential-barrier effect on species transport, and the resulting deposition rate under variations in magnetic-field strength, pressure, and applied power
Publication Details
Publication Date
2010-06-15
Journal
Publisher
ISSN
Cited by
132
Open access PDF
Access Type
Author Information
Download PDF
Subscribe to digest
References available in scid.ai2
Cited by14
Plasma diagnostics for understanding the plasma–surface interaction in HiPIMS discharges: a review2014
Origin of the energetic ions at the substrate generated during high power pulsed magnetron sputtering of titanium2014
Deposition rate enhancement in HiPIMS without compromising the ionized fraction of the deposition flux2013
Understanding deposition rate loss in high power impulse magnetron sputtering: I. Ionization-driven electric fields2012
On the HiPIMS benefits of multi-pulse operating mode2014
Dynamic of the growth flux at the substrate during high-power pulsed magnetron sputtering (HiPIMS) of titanium2013
Transport and ionization of sputtered atoms in high-power impulse magnetron sputtering discharges2013
Sideways deposition rate and ionized flux fraction in dc and high power impulse magnetron sputtering2020
Ionization of sputtered material in high power impulse magnetron sputtering plasmas—comparison of titanium, chromium and aluminum2023
Target ion and neutral spread in high power impulse magnetron sputtering2022
Ionized particle transport in reactive HiPIMS discharge: correlation between the energy distribution functions of neutral and ionized atoms2021
Hard AlN films prepared by low duty cycle magnetron sputtering and by other deposition techniques2017
Particle-based simulation of atom and ion transport in HiPIMS: effect of the plasma potential distribution on the ionized flux fraction2023
Azimuthal ion movement in HiPIMS plasmas—Part II: lateral growth fluxes2023