Hard AlN films prepared by low duty cycle magnetron sputtering and by other deposition techniques

Твердые пленки AlN, полученные методом магнетронного распыления с низким коэффициентом заполнения и другими методами осаждения
Jiří Kohout, Ludvik Martinu, O. Zabeida, J.E. Klemberg-Sapieha, Jincheng Qian, Thomas Schmitt, Richard Vernhes
2017-08-17

(002) preferential orientationAlN filmshardnesslow duty cycle pulsed DC magnetron sputteringreactive deposition
Crystalline AlN films are very attractive due to their properties such as high thermal stability and relatively high hardness and piezoelectric response. However, the deposition of dense textured AlN films with superior quality at a high deposition rate remains a challenge. In the present work, a reactive low duty cycle pulsed direct current magnetron sputtering (LDMS) process was employed to deposit AlN films on glass and silicon substrates. An arc-free discharge on the Al target was achieved by using short voltage pulses of 10 μs at a low duty cycle of 10%. The authors optimized the deposition conditions in terms of reactive gas flow, working pressure, average target power, substrate temperature, substrate bias, and the level of target erosion. With the optimized deposition conditions, the authors were able to obtain transparent crystalline AlN films with strong (002) preferential orientation and very good optical and mechanical properties: The AlN films with the highest refractive index of 2.1 present a hardness of up to 22 GPa and a low residual stress of ≈+300 MPa. Meanwhile, a relatively high deposition rate of ≈45 nm/min was achieved. A systematic comparison of the LDMS process with five other magnetron sputtering approaches working at optimized conditions indicated superior performance of the LDMS technique. This approach leads to the most promising results in terms of discharge stability, deposition rate, and film properties, and thus, it shows much promise for reactive deposition of dielectric materials and hard optical coatings.
1
Compared with five other optimized magnetron-sputtering approaches, LDMS showed superior discharge stability, deposition rate, and film properties.
2
Optimized films reached a refractive index of 2.1, hardness up to 22 GPa, and low residual stress of approximately +300 MPa.
3
Reactive low-duty-cycle pulsed DC magnetron sputtering deposited transparent, crystalline AlN films with strong (002) preferential orientation.
4
The optimized process achieved a relatively high AlN deposition rate of approximately 45 nm/min.
5
Using 10 μs voltage pulses at a 10% duty cycle enabled arc-free discharge on the aluminum target.

Crystalline AlN films deposited on glass and silicon substrates

The effects of low-duty-cycle magnetron sputtering deposition conditions and technique on AlN film structure, optical and mechanical properties, deposition rate, and discharge stability

Publication Details
Publication Date
2017-08-17
Journal
Publisher
ISSN
Cited by
12
Access Type
Author Information
Authors
Jiří Kohout
Ludvik Martinu
O. Zabeida
J.E. Klemberg-Sapieha
Jincheng Qian
Thomas Schmitt
Richard Vernhes
Explore further
Open the scid.ai AI chat with a ready-made request: it will find papers on a similar topic and help build a literature review.
Find similar papers in the chat →
Make a presentation
100%